Nugeon 99-05425A rear right brake caliper for the 2010-2012 Land Rover Range Rover and other vehicles presses the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper works from hydraulic pressure, which pushes its piston to clamp the pads.
A failing caliper can show up as the vehicle pulling to one side, a brake that drags, or brake fluid around the dust boot. During a brake service, with the engine off, look at the rear right for fluid at the boot or hose fitting and for unevenly worn pads, since a pad or hose problem can cause similar signs.
This caliper fits the 2010-2012 Land Rover Range Rover, the 2010-2012 Land Rover Range Rover Sport and the 2010-2012 Land Rover LR4. Calipers are normally replaced as a left and right pair on the same axle, but this listing is one caliper for the rear right; the rear left is a separate part. The rear axle on each of these has one caliper on either side.
Fit and size
Build and materials
One brake caliper with its mounting bracket, caliper slides, dust boots, bleeder screw and crush washers. Brake pads, anti-squeal shims, wear sensors, a bleeder screw cap and caliper and pad hardware are not included. Bracket mounting bolts are not included either, so plan on new ones.
Are these Range Rover calipers right for the 2010-2012 Land Rover Range Rover?
Yes. Nugeon 99-05425A is the rear right caliper for the 2010-2012 Land Rover Range Rover. The rear left is a separate part.
Does this Nugeon caliper come with brake pads?
No. This rear right caliper comes with its bracket, slides, dust boots, bleeder screw and crush washers. Brake pads, shims and bracket mounting bolts are not included.
What size is the piston on the 99-05425A brake caliper?
Nugeon 99-05425A has a single steel piston that measures 45 mm (1.772 in) across. The inlet port and bleeder screw both use an M10-1.0 thread.
Can a sticking rear right disc brake caliper make the car pull to one side?
Yes. A sticking caliper can make the car pull, drag, or leave fluid at the dust boot. If you notice these signs, have a shop inspect the brake promptly.
Is the housing on this rear right caliper aluminum?
Yes. The housing is an aluminum casting with a rust-preventative finish, and this Nugeon caliper is remanufactured.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
