Nugeon 99-17770A rear right brake caliper for the 2012-2020 Dodge Journey clamps the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper replaces a worn or leaking unit on the rear right wheel.
Pulling to one side, a dragging brake or fluid around the wheel can mean a disc brake caliper is sticking or leaking. Before you replace this one, rule out a collapsed brake hose, worn pads and a stuck slide, because each of them can also produce a pull or a drag.
This 2012-2020 Dodge Journey brake caliper is a direct-fit replacement for the rear right wheel. This listing is one caliper for the rear right; the rear left, on the same axle, is a separate part and is normally replaced at the same time.
Fit and size
Build and materials
This listing holds one caliper, and the rear right takes one; the rear left is ordered separately. The caliper comes with its mounting bracket, caliper slides, dust boots, bleeder screw, crush washer and caliper and pad hardware. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap and the mounting bolts, including those for the bracket, are not included; plan on new bolts, since the old ones may not be reusable.
Is this the rear brake caliper for a 2013 Dodge Journey?
Yes. Nugeon 99-17770A is the rear right caliper for the 2012-2020 Dodge Journey, which includes the 2013 model year. The rear left is a separate part.
Does this Nugeon caliper come with brake pads?
No. Brake pads are sold separately. Nugeon 99-17770A includes the bracket, slides, dust boots, bleeder screw, crush washer and hardware, but not anti-squeal shims, wear sensors or mounting bolts.
What are the piston size and material on this rear right caliper?
This caliper has one steel piston with a 45.31 mm (1.78 in) outside diameter. It is a floating design with a cast iron housing.
Can a dragging or pulling brake mean the rear right caliper is failing?
Yes, it can. A caliper that sticks or leaks may pull the vehicle to one side, drag, or leave fluid at the wheel, so have the brakes inspected promptly.
What thread sizes do the banjo inlet and bleeder screw have on Nugeon 99-17770A?
The banjo inlet port is M10-1.0 x 23.4 mm and the bleeder screw is M10-1.0. The bleeder screw and crush washer are included, but the bleeder screw cap is not.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
