Nugeon Disc Brake Caliper P/N:99-01189B
Nugeon 99-18039A front right brake caliper for the 2003-2007 Ford E-250 and other vehicles presses the pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper, also called a disc brake caliper, is a floating two-piston design.
A caliper that leaks fluid at the piston boot, drags or sticks can pull the vehicle to one side or wear the pads unevenly. During a brake service, with the wheel off and the brakes cool, look for wet fluid around the boot and for a stuck slide before you replace the caliper, since a stuck slide may be behind the drag or uneven wear instead. Front calipers are normally replaced as a pair; this listing is one caliper for the front right, and the front left is ordered separately. The 2005-2007 Ford E-450 Super Duty takes one at the front right.
It is a direct-fit replacement for a wide range of Ford models, including the 2003-2007 Ford E-250, the 1999-2007 Ford E-350 Super Duty and the 2005-2007 Ford E-450 Super Duty.
Fit and size
Build and materials
One caliper with its bracket, caliper slides, dust boots, bleeder screw, crush washer, pad hardware and mounting hardware. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap and the bracket mounting bolts are not included, so plan on new bolts.
Does this front right brake caliper fit as a 2003-2007 Ford E-250 brake caliper?
Yes. Nugeon 99-18039A is a front right caliper for the 2003-2007 Ford E-250. If your vehicle is another model, look up your year and model in the "Vehicles it fits" section.
Will Nugeon 99-18039A work as a Ford E-450 Super Duty brake caliper on a 2005-2007 model?
Yes, the 2005-2007 Ford E-450 Super Duty is listed, for the front right position. The front left caliper is a separate part.
Does this Nugeon caliper come with brake pads?
No. Pads, anti-squeal shims, wear sensors and the bleeder screw cap are not included. The bracket mounting bolts are also separate, so plan on new bolts.
What size are the pistons on Nugeon 99-18039A?
Nugeon 99-18039A has two phenolic pistons, each 56.01 mm (2.21 in) in outside diameter, in a floating caliper with a cast iron housing.
Does this caliper use a banjo fitting?
Yes. The inlet is a banjo fitting with a 3/8-24 thread, and the bleeder screw is 3/8-24 x 1. A crush washer comes with it.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.