Standard Ignition ALS897 front left ABS wheel speed sensor for the 1992-1994 Mitsubishi Montero reports front left wheel speed to the ABS. It reads wheel rotation and passes that signal on to the electronic safety systems.
- Synthetic material construction made to withstand harsh operating conditions
- Sealed connector for protection in harsh conditions
- Tested on vehicles for correct integration with electronic safety systems
Quick facts
- Part: Standard Ignition ALS897 ABS wheel speed sensor
- Fits: 1992-1994 Mitsubishi Montero
- Position: Front left
- Condition: New
An ABS warning light or odd wheel-speed behavior can mean this sensor is worn, though a damaged wire in the harness or a damaged tone ring can be behind the same signs, so find the cause before you replace anything.
Fits
This sensor is a direct-fit replacement for the 1992-1994 Mitsubishi Montero.
Specifications
Fit and size
- Position: Front left
- Quantity per vehicle: 1
- Harness length: 36 in (914 mm)
- Number of bolt holes: 2
Build and materials
- Connector: 1 square, female
- Terminals: 2, male blade
- Condition: New
- Country of origin: Japan
In the box
One ABS wheel speed sensor. Mounting hardware is not included, so plan on new bolts, as the old ones may not be reusable. This listing is one sensor for the front left, and the front left takes one; the front right is a separate part.
Installation notes
- OE location grommets and wire clips are included on the harness for proper mounting and routing, which saves technicians time.
Interchange: ABS1007 · ABSC20649 · 530422 · MB668260
This part cross-references / interchanges with the following part numbers:
ABS1007, ABSC20649, 530422, MB668260, ALS897
Frequently Asked Questions
Does the Standard Ignition ALS897 fit the 1992-1994 Mitsubishi Montero?
Yes. Standard Ignition ALS897 is the front left ABS wheel speed sensor for the 1992-1994 Mitsubishi Montero. The front right side is a separate part.
How long is the harness on this front left wheel speed sensor?
The harness is 36 inches (914 mm) long and ends in a square female connector.
Do the grommets and wire clips come with the ALS897 ABS sensor?
Yes, Standard Ignition ALS897 has OE location grommets and wire clips on the harness. Mounting hardware is not included.
What might I notice when a front left ABS sensor is going bad?
The ABS warning light can come on, or the ABS may act oddly. A shop can read the codes and test the circuit.
What kind of connector is on this Standard Ignition ABS wheel speed sensor?
It has one square female connector with two male blade terminals. The connector is sealed for protection in harsh conditions.
