Standard Ignition ALS915 rear left ABS wheel speed sensor for the 1992-1996 Mitsubishi Diamante reads wheel rotation and reports it to the ABS module. This Standard Ignition ABS wheel speed sensor is engineered specifically for Mitsubishi vehicles.
- Synthetic material made to withstand harsh operating conditions
- Grommets and wire clips on the harness for proper mounting and routing
- Sealed connector for protection in harsh conditions
- Tested on vehicles for correct integration with electronic safety systems
Quick facts
- Part: Standard Ignition ALS915 ABS wheel speed sensor
- Fits: 1992-1996 Mitsubishi Diamante
- Position: Rear left
- Condition: New
A lit ABS warning light or an ABS that stops working can mean a wheel speed sensor has failed. These signs alone do not prove the sensor is the problem, since a damaged tone ring or a wiring fault can set the same light. This listing is one sensor for the rear left wheel; the rear right wheel takes its own, ordered separately.
Fits
This sensor is a direct-fit replacement for the 1992-1996 Mitsubishi Diamante.
Specifications
Fit and size
- Position: Rear left
- Quantity per vehicle: 1
- Mounting location: Wheel
- Bolt holes: 1
- Harness length: 27.5 in (698.5 mm)
Build and materials
- Connector: rectangular, male, 1
- Terminals: 2, blade, female
- Condition: New
- Country of origin: Japan
In the box
One rear left ABS wheel speed sensor with its harness. Mounting hardware is not included, so plan on a new bolt, as the old one may not be reusable.
Interchange: ABS1025 · ABSD31152 · 530282 · MB618907
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
ABS1025, ABSD31152, 530282, MB618907, ALS915
Frequently Asked Questions
Does the Standard Ignition ALS915 fit the 1992-1996 Mitsubishi Diamante?
Yes, the Standard Ignition ALS915 is a rear left ABS wheel speed sensor for the 1992-1996 Mitsubishi Diamante; the rear right side takes a separate sensor.
Does this rear left ABS wheel speed sensor come with a mounting bolt?
No. Mounting hardware is not included, so plan on a new bolt; the sensor's harness is 27.5 in (698.5 mm) long.
What kind of connector does the Standard Ignition ALS915 use?
The Standard Ignition ALS915 has one rectangular male connector with two female blade terminals. The connector is sealed for protection in harsh conditions.
How can I tell if a rear ABS wheel speed sensor is going bad?
An ABS warning light can be one sign, and the ABS may stop working. A shop can scan for codes to find which wheel and what fault set the light.
Does the Standard Ignition ALS915 replace number MB618907?
Yes, MB618907 is one of the numbers the Standard Ignition ALS915 replaces, and the others are on the Interchange line.
