Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2694
$83.99
(You save)
Locate the front wheel and let it pivot through steering and suspension travel with the Delphi control arm TC2694, a front right lower suspension control arm and ball joint assembly. It installs as a direct-fit replacement for the front right lower position on the 2005-2007 Buick Terraza, 2005-2009 Chevrolet Uplander, 2005-2009 Pontiac Montana, and 2005-2007 Saturn Relay — see the Buyer's Guide tab for engine-level fitment.
OE-derived engineering: Delphi applies its OE expertise to its aftermarket steering portfolio and tests to the extreme — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray.
100% inspected: every arm undergoes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball stud: the ball studs are machined to micron tolerances for durable, smooth joint operation.
Robot-welded & protected: robot welding delivers consistent quality, and anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance.
The arm positions the front wheel while the integrated ball joint allows it to steer and move over bumps. If a worn arm or ball joint is behind clunking on acceleration or over bumps, loose steering, or uneven tire wear, this assembly replaces it. Sold individually; for balanced handling, consider replacing the matching side.
What vehicles does the Delphi TC2694 control arm fit?
It's a direct-fit replacement for the front right lower position on the 2005-2007 Buick Terraza, 2005-2009 Chevrolet Uplander, 2005-2009 Pontiac Montana, and 2005-2007 Saturn Relay. See the Buyer's Guide tab for engine-level detail.
Is this a control arm and ball joint assembly?
Yes. TC2694 is a suspension control arm with the ball joint pre-installed, so you replace both the arm and the joint as one unit for the front right lower corner.
Will this fit my Uplander?
Yes, this Uplander control arm covers the 2005-2009 Chevrolet Uplander in the front right lower position. Check the Buyer's Guide tab to confirm your specific configuration.
What are signs I need to replace this part?
Clunking on acceleration or over bumps, loose or wandering steering, and uneven front tire wear can point to a worn control arm or ball joint. Diagnose the cause before replacing.
How is this Delphi part built and tested?
Delphi machines the ball studs to micron tolerances, robot-welds the arm, and runs 100% crack and ultrasonic flaw detection. Parts are tested from below -40°C to over 120°C with 720 hours of salt spray.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC2694
Suspension Control Arm and Ball Joint AssemblyDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio...
Suspension Control Arm and Ball Joint AssemblyDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio...
Suspension Control Arm and Ball Joint AssemblyDelphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio...
Tighten up steering and hold your alignment with the Delphi control arm and ball joint assembly (TC5797), a front left upper unit built for the 2003-2011 Ford Crown Victoria, 2003-2011 Lincoln Town...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
