Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3472
$124.99
(You save)
Help maintain precise steering and smooth suspension travel with the Delphi control arm and ball joint assembly, MPN TC3472. This is the front left upper unit, and it drops in as a direct-fit replacement for many vehicles, among them the 2010-2011 Mercedes-Benz C250, 2008-2011 Mercedes-Benz C300 and 2008-2011 Mercedes-Benz C350 (see the Buyer's Guide tab for the full list and engine-level fitment). It locates the wheel and supports the corner of the suspension while its ball joint allows the steering and travel movement.
OE-derived engineering: Delphi applies its OE steering expertise to the aftermarket, with dimensional and material analysis for close compatibility between the OE and aftermarket part.
Tested to extremes: validated below -40°C and above 120°C, plus 720 hours of salt spray exposure.
Quality-verified: 100% crack detection and ultrasonic flaw detection help materials match OE specifications; ball studs are machined to micron tolerances.
Robot-welded for consistent build, with anti-corrosion protection applied for corrosion prevention and appearance.
Signs this assembly may need replacing include clunking on acceleration or over bumps, loose or wandering steering, and uneven tire wear.
It is a suspension control arm with ball joint for the front left upper position, combining the control arm and its ball joint in one unit.
Which vehicles does it fit?
It fits many vehicles, among them the 2010-2011 Mercedes-Benz C250, 2008-2011 Mercedes-Benz C300 and 2008-2011 Mercedes-Benz C350. See the Buyer's Guide tab for the full list.
Is this the right C300 control arm for a 2008-2011 Mercedes-Benz C300?
Yes, it is listed for the 2008-2011 Mercedes-Benz C300 in the front left upper position. Confirm the year and engine against the Buyer's Guide tab before ordering.
How does Delphi test this part?
Delphi validates these parts below -40°C and above 120°C and through 720 hours of salt spray, plus 100% crack and ultrasonic flaw detection.
What are signs this control arm may need replacing?
Clunking on acceleration or over bumps, loose or wandering steering, and uneven tire wear can indicate a worn arm or ball joint. Diagnose the cause before replacing.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3472
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Help restore tight, controlled handling with the Delphi control arm — the Suspension Control Arm and Ball Joint Assembly TC7246. It installs in the rear left upper position as a direct-fit...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
Delphi's OE safety technology is fitted to millions of vehicles worldwide and we apply Delphi's OE expertise to our aftermarket steering portfolio. Delphi tests to the extreme for OE performance at...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
