Delphi TC7246 rear left upper control arm with ball joint for the 2003-2007 Cadillac CTS connects the wheel to the vehicle and lets the suspension move. It is sold as a control arm and ball joint assembly, so the arm and joint come as one piece.
- Tested below -40 degrees C and over 120 degrees C, and exposed to 720 hours of salt spray
- Delphi control arms undergo 100% crack detection and ultrasonic flaw detection
- Ball studs machined to micron tolerances for durability and smooth joint operation
- Robot welding for consistent performance and quality
- Anti-corrosion protection applied to each part
Quick facts
- Part: Delphi TC7246 control arm with ball joint
- Also called: control arm and ball joint assembly
- Fits: 2003-2007 Cadillac CTS
- Position: Rear left upper
- Condition: New
A clunk over bumps, uneven tire wear or a loose feel at the rear of the car can mean this arm or its ball joint is worn, though a tired bushing or a weak shock can be behind the same signs.
Fits
It is a direct-fit rear left upper control arm for the 2003-2007 Cadillac CTS.
Specifications
Fit and size
- Position: Rear left upper
- Quantity per vehicle: 1 (rear left side)
Build and materials
- Type: control arm with ball joint, robot welded
- Corrosion protection: anti-corrosion protection on each part
- Condition: New
In the box
One rear left upper control arm with ball joint. The 2003-2007 Cadillac CTS takes one on this side; the rear right is a separate part, and both sides are normally replaced together.
Interchange: 522-489
25684651 · CB90507 · CB90507PR · RK622079 · CMS501176
This part cross-references / interchanges with the following part numbers:
522-489, 25684651, CB90507, CB90507PR, RK622079, CMS501176
Frequently Asked Questions
Is the Delphi TC7246 the right control arm for a 2003-2007 Cadillac CTS?
Yes. Delphi TC7246 is a rear left upper control arm with ball joint for the 2003-2007 Cadillac CTS. The rear right side is a separate part.
Does the Delphi TC7246 come with the ball joint?
Yes. Delphi TC7246 is a control arm with ball joint, so the arm and joint come as one piece. This listing is one rear left upper arm.
How are the ball studs on this rear left upper control arm made?
The ball studs are machined to micron tolerances for durability and smooth joint operation. The arms themselves are robot welded for consistent performance and quality.
Can a worn ball joint on this control arm make noise?
Yes. A worn ball joint can show up as a clunk from the rear when going over bumps. A shop can inspect the rear suspension, and a worn part should be replaced promptly.
How is the Delphi TC7246 tested for temperature and corrosion?
The parts are tested below -40 degrees C and over 120 degrees C and exposed to 720 hours of salt spray. Anti-corrosion protection is applied to each part.
