Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8272
$176.99
(You save)
Tighten up loose, clunky steering with the Delphi control arm — this front right upper Control Arm with Ball Joint, MPN TC8272. It installs as a direct-fit replacement for the 2012-2013 Tesla S, locating the wheel and letting it pivot while the integrated ball joint allows steering and suspension movement. See the Buyer's Guide tab for engine-level applications.
OE-derived engineering: Delphi applies its OE steering expertise to the aftermarket, testing to the extreme — parts withstand temperatures below -40°C and over 120°C and endure 720 hours of salt spray, with dimensional and material analysis for close OE-to-aftermarket compatibility.
Verified materials: Each control arm undergoes 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision joint: Ball studs are machined to micron tolerances for durability and smooth joint operation.
Built consistent: Robot welding delivers consistent performance and quality, and anti-corrosion protection is applied for corrosion prevention and enhanced appearance.
If a worn front right upper arm or ball joint is behind your steering wander, uneven tire wear, or clunking, this assembly replaces it. Read the Delphi control arm reviews and check fitment before ordering.
It locates the wheel and lets it move through the suspension travel while the integrated ball joint allows the steering knuckle to pivot. This unit combines both into one front right upper assembly.
Does the Delphi TC8272 fit my Tesla?
It is a direct-fit replacement for the 2012-2013 Tesla S front right upper position. See the Buyer's Guide tab and confirm fitment for your vehicle before ordering.
What position on the vehicle does this replace?
This assembly is the front right (passenger side) upper control arm with ball joint. It is not the lower or left-side arm.
What signs suggest I may need this part?
Steering wander, clunking over the front suspension, or uneven tire wear can point to a worn arm or ball joint. Have the cause diagnosed, since these symptoms can have other sources.
How is this Delphi arm protected against corrosion?
Anti-corrosion protection is applied to each part for corrosion prevention and enhanced appearance. It is also validated through 720 hours of salt spray testing.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC8272
Restore precise wheel location and smooth, controlled steering with the Delphi control arm and ball joint assembly (TC1346), a direct-fit replacement for the rear left upper rearward position on the...
Restore steering precision and confident wheel control with the Delphi control arm and ball joint assembly (P/N: TC5901), a direct-fit replacement for the front left upper position on the 2003-2004...
Steer with confidence and keep your front suspension tight with the Delphi control arm and ball joint assembly (P/N: TC6247). This is the front left upper unit, dropping in as a direct-fit...
Keep your steering precise and your ride stable with the Delphi control arm and ball joint assembly (P/N: TC1393), a direct-fit replacement for the front right lower rearward position on the...
Tighten up your Audi's front end and quiet a worn joint with the Delphi control arm and ball joint assembly (TC2455) — a Delphi control arm that installs as a front right lower rearward, direct-fit...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
