Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:524-524
Dorman 524-288 front right lower control arm with ball joint for the 1996-2004 Nissan Pathfinder and other vehicles links the front right wheel to the chassis and carries the ball joint. This control arm and ball joint assembly is a direct replacement for the original equipment on specific vehicle applications.
A worn lower control arm or ball joint can show up as a clunk over bumps, loose or wandering steering, or uneven front tire wear. Before you replace the arm, rule out worn tie rods, a loose wheel bearing and tired shocks or struts, since those parts can also give some of these symptoms. A shop can test the front end if you are unsure.
It fits the 1996-2004 Nissan Pathfinder and the 1997-2003 Infiniti QX4, and each takes one for this front right lower position. This listing is a single arm; the front left lower arm is a separate part ordered separately, and the two sides are normally replaced together.
Fit and size
Build and materials
One control arm with ball joint, with bushings installed, plus mounting hardware. A grease fitting is not included.
Interchange: TC5436 · CA14578 · 9CB30485 · RK640329 · CMS301239 · 2608815 · 545000W000 · 545000W001 · X36CJ2958
This part cross-references / interchanges with the following part numbers:
Will Dorman 524-288 work as a 1996-2004 Nissan Pathfinder control arm?
Yes. Dorman 524-288 is a front right lower control arm with ball joint for the 1996-2004 Nissan Pathfinder, and it also fits the 1997-2003 Infiniti QX4.
Is this the right or left 1996-2004 Nissan Pathfinder lower control arm?
This one is for the front right lower position. The front left is a separate part and is ordered separately.
Are the Dorman control arm bushings already installed?
Yes. Dorman 524-288 comes with rubber bushings and the ball joint pre-installed. Mounting hardware is included; a grease fitting is not.
Is this Dorman lower control arm made of steel?
Yes. The control arm is steel with rubber bushings, and additional coatings give it rust and corrosion resistance.
What thread size does the ball joint stud have on this Dorman control arm?
The ball joint stud is threaded, with a 14 mm thread diameter. The mounting hole measures 12.3 mm.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.