Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7844
$269.99
(You save)
Locate the front wheel and pivot the steering knuckle with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-7844, a front right lower unit that installs as a direct-fit replacement for the 2011-2012 Honda CR-Z. It combines the control arm with a pre-assembled ball joint, so it positions the wheel, supports suspension loads, and lets the knuckle pivot as you steer and travel over bumps.
OE fit: Matches OE form, fit, and function for the listed application.
Complete unit: The control arm comes with the ball joint already fitted for a complete installation.
Construction: Steel, iron, or aluminum construction for durability and rust/corrosion resistance.
Hardware: New hardware and bushings included where applicable; application specific for this vehicle.
Signs the original may need replacing include clunking or knocking over bumps, uneven or accelerated tire wear, popping in turns, and loose or wandering steering. Diagnose the cause before replacing, since these signs can have other sources.
It is a direct-fit replacement for the 2011-2012 Honda CR-Z. See the Buyer's Guide tab to confirm the exact engine and trim for your vehicle.
What position is this control arm for?
This is the front right lower control arm and ball joint assembly for the listed application.
Does it include the ball joint?
Yes. The control arm comes with the ball joint already fitted, so it installs as a complete unit.
Are hardware and bushings included?
New hardware and bushings are included where applicable for this application. Consult the vehicle service information for the correct fasteners and whether any may be reused.
What are common signs this part may need replacing?
Clunking or knocking over bumps, uneven tire wear, popping in turns, and loose or wandering steering. Have the cause diagnosed, since these signs can come from other worn parts.
Write a Review
Beck/Arnley
Beck/Arnley Suspension Control Arm and Ball Joint Assembly P/N:102-7844
Tighten up your Lexus's ride and restore precise wheel location with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8199. This rear left upper unit installs as a direct-fit...
Keep the front suspension properly located with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8103, a front right lower unit that installs as an application-specific replacement...
Restore steering precision and quiet the clunks with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly (P/N 102-5535, also written 1025535). This front left upper control arm arrives...
Keep your front suspension properly located and your steering tight with the Beck/Arnley Suspension Control Arm and Ball Joint Assembly 102-8380. This front right lower assembly drops in as a direct...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
