Raybestos Brakes Disc Brake Caliper P/N:FRC11034
Replace a worn rear left brake caliper with the Raybestos R-Line FRC11962, a remanufactured, semi-loaded disc brake caliper and bracket assembly whose floating design clamps the pads against the rotor to slow the wheel. It fits many vehicles, among them the 2007-2017 Jeep Compass, 2007-2017 Jeep Patriot and 2008-2014 Dodge Avenger (all engines). See the Buyer's Guide tab for the full list.
R-Line non-plated calipers are remanufactured OE units. All rubber and sealing components are new, and the castings, guide pins and brackets are carefully inspected before they are reused. Each caliper is rigorously tested.
Specifications: floating caliper type; cast iron casting; 34.9 mm (1.374 in) piston diameter; M7x1 bleeder screw thread; 10 mm bracket mounting hole size with a 1.25 mm thread pitch. Position: rear left. Quantity per application: 1. Country of origin: Mexico.
Signs a caliper may need replacing include brake fluid seeping at the caliper, a brake that drags or stays applied, uneven pad wear, or the vehicle pulling to one side. Diagnose the cause first, because pads, hoses or hardware can produce similar symptoms.
Interchange: 99-17729B · 18-B5039 · 18-P5039 · 141.63534 · 10-1268S · 14-1268
9917729B · 18B5039 · 18P5039 · 14163534 · 101268S · 141268 · SC0209
This part cross-references / interchanges with the following part numbers:
Is this the right 2007-2017 Jeep Compass brake caliper for the rear left wheel?
Yes. FRC11962 is cataloged for the rear left position on the 2007-2017 Jeep Compass with all engines.
Will it also work as a 2007-2017 Jeep Patriot brake caliper?
Yes. It is listed for the rear left position on the 2007-2017 Jeep Patriot and the 2008-2014 Dodge Avenger, all engines.
What is this unit, and which parts are new?
It is a remanufactured semi-loaded caliper and bracket assembly. Its seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings are replaced with new materials.
What are the key specifications?
It is a floating caliper with a cast iron casting, a 34.9 mm (1.374 in) piston, an M7x1 bleeder screw thread, and 10 mm bracket mounting holes with a 1.25 mm thread pitch.
Do I need to bleed the brakes after installing it?
Yes. Replacing a hydraulic caliper opens the brake system, so bleed it afterward. Follow the vehicle service information for torque specs and for whether fasteners may be reused.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.