Delphi FE0673 fuel pump and strainer set for the 2007-2010 Chevrolet Cobalt 4-cylinder 2.2L and other vehicles moves fuel from the tank to the engine. The set pairs the pump with a strainer and is built to Delphi's OE standards.
- Delphi pump designed for extreme temperatures and quick engine starts
- Lower amperage draw puts less load on the vehicle's electrical system
- Designed to bring back fast fuel pressure with less pumping energy
- Fuel pump validated and tested as a part
- Pump and strainer supplied together as one set
Quick facts
- Part: Delphi FE0673 fuel pump and strainer set
- Fits: 2007-2010 Chevrolet Cobalt 4-cylinder 2.2L and other vehicles
A weak fuel pump can show up as hard starting, stalling or a loss of power. A clogged fuel filter, a dirty tank or a bad fuel pump relay can be behind those signs too, so find out which one it is before you buy a pump.
Fits
It fits the 2007-2010 Chevrolet Cobalt 4-cylinder 2.2L, the 2007-2009 Pontiac G5 4-cylinder 2.2L and the 2007 Saturn Ion 4-cylinder 2.2L. The 2007-2010 Chevrolet Cobalt 4-cylinder 2.2L takes one set, and so does each of the others.
Specifications
- Type: fuel pump and strainer set
- Quantity per vehicle: 1
In the box
One fuel pump and strainer set, one seal and one instruction sheet.
Installation notes
- Replace the fuel strainer whenever the fuel pump is repaired; this set includes one.
- Check and clean the fuel tank during the job.
- The instruction sheet in the box covers the steps.
Interchange: EP1023 · 4020331 · E3784 · E6784 · CFE0673 · P76827 · 19167186 · B0083E · E16458 · SP1296 · USEP3784
This part cross-references / interchanges with the following part numbers:
EP1023, 4020331, E3784, E6784, CFE0673, P76827, 19167186, B0083E, E16458, SP1296, USEP3784
Frequently Asked Questions
Is this a fuel pump for the 2007-2010 Chevy Cobalt 4-cylinder 2.2L?
Yes. Delphi FE0673 is listed for the 2007-2010 Chevrolet Cobalt 4-cylinder 2.2L, and that engine takes one set.
Does the Delphi fuel pump assembly FE0673 come with a strainer?
Yes. Delphi FE0673 is a fuel pump and strainer set, and the box also holds a seal and an instruction sheet.
Is this Delphi fuel pump designed for low amperage draw?
Yes. Delphi FE0673 is designed to draw lower amperage, which puts less load on the vehicle's electrical system. It is also built to Delphi's OE standards.
Should I swap the strainer during a Delphi fuel pump replacement?
Yes. The strainer should be replaced whenever the pump is repaired, and the set already includes one. Check and clean the fuel tank at the same time.
Does Delphi FE0673 replace number E3784?
Yes. E3784 is one of the numbers Delphi FE0673 replaces, along with EP1023 and 4020331.
