Delphi HP10136 fuel pump and sender assembly for the 2005-2010 Ford Crown Victoria V8 4.6L and other vehicles pumps fuel from the tank to the engine. The assembly holds the pump and float arm in the tank, and the float position sets the gas gauge reading.
- Metal tubes in the hanger are routed so they never touch the tank, which avoids noise and vibration
- Empty float height and float retention are set to give a correct gas gauge reading
- Pump designed to operate under extreme temperatures with quick engine starts
- Lower amperage draw puts less load on the vehicle's electrical system
- Fast pressure performance and system integrity, with pumping that uses less energy
Quick facts
- Part: Delphi HP10136 fuel pump and sender assembly
- Fits: 2005-2010 Ford Crown Victoria V8 4.6L and other vehicles
- Condition: New
A hard start, stalling, a whine from the tank or a gas gauge that reads wrong can mean the pump or float is wearing out. Those signs alone don't prove it, since a wiring fault can cause some of them too. If the pump is the cause, this assembly replaces it. The car takes a single assembly in the tank.
Fits
This fuel pump assembly fits the 2005-2010 Ford Crown Victoria V8 4.6L, the 2005-2010 Lincoln Town Car V8 4.6L and the 2005-2010 Mercury Grand Marquis V8 4.6L.
Specifications
- Quantity per vehicle: 1
- Float arm: included
- Condition: New
In the box
One fuel pump and sender assembly with float arm, six bolts, six washers, two retainer clips and an instruction sheet.
Installation notes
- Check and clean the fuel tank before installing the assembly.
- The instruction sheet in the box covers the steps.
Product information is for general reference and may contain errors. See our Disclaimer.
Frequently Asked Questions
Is this the right fuel pump for the 2005-2010 Ford Crown Victoria V8 4.6L?
Yes. Delphi HP10136 fits the 2005-2010 Ford Crown Victoria V8 4.6L, and the car takes one assembly in its tank.
Is this a fuel pump for the 2005-2010 Mercury Grand Marquis V8 4.6L?
Yes. Delphi HP10136 fits the 2005-2010 Mercury Grand Marquis V8 4.6L, with one assembly in the tank.
Does the Delphi pump come with bolts and a float arm?
Yes. Delphi HP10136 includes the float arm, six bolts, six washers, two retainer clips and an instruction sheet.
Does the float on this Delphi fuel pump assembly give a correct gas gauge reading?
Yes. On this Delphi fuel pump assembly, the empty float height and float retention match OE specifications, which is meant to give a correct gas gauge reading.
Should the tank be prepared before installing this fuel pump assembly?
Check and clean the fuel tank first. The instruction sheet in the box covers the installation steps.
