Delphi HP10167 fuel pump hanger for the 1986-1988 Ford Bronco II V6 2.9L mounts in the fuel tank and carries the float arm for the gas gauge. This fuel pump hanger assembly is validated, tested and matched to the right vehicle application.
- Designed to operate under extreme temperatures with quick engine starts
- Metal tubes routed so they never touch the tank, which avoids noise and vibration in operation
- Empty float height and float retention set for a correct gas gauge reading
- Design and durability for lower failure rates
- Lower amperage draw, so less load on the vehicle's electrical system
Quick facts
- Part: Delphi HP10167 fuel pump hanger
- Also called: fuel pump hanger assembly
- Fits: 1986-1988 Ford Bronco II V6 2.9L
- Condition: New
A gas gauge that reads wrong, hard starting or a stumbling engine can come from the hanger. A fuse, a connector or the fuel filter can produce the same complaints, so look those over with the engine off before replacing the hanger, and leave fuel pressure tests to a shop.
Fits
It fits the 1986-1988 Ford Bronco II V6 2.9L.
Specifications
- Quantity per vehicle: 1
- Condition: New
In the box
One fuel pump hanger with float arm, seal, lock ring and instruction sheet; the 1986-1988 Ford Bronco II V6 2.9L takes one.
Installation notes
- Check and clean the fuel tank before installing the hanger.
- An instruction sheet comes with the part for the steps.
Interchange: 951-3000 · E8TZ 9H307-EA · PFS-146
4011096 · 4017033 · E2097S · E2486 · DHP10167 · 67069 · 69115 · P74069 · P74550S · AFS1004P · RE0055S · RE1004P · C0020H · A27049 · E16109 · SP1167 · SP378H · USEP2097S
This part cross-references / interchanges with the following part numbers:
4011096, 4017033, E2097S, E2486, DHP10167, 67069, 69115, P74069, P74550S, 951-3000, AFS1004P, RE0055S, RE1004P, E8TZ 9H307-EA, PFS-146, C0020H, A27049, E16109, SP1167, SP378H, USEP2097S
Frequently Asked Questions
Does the Delphi HP10167 fit a 1986-1988 Ford Bronco II V6 2.9L?
Yes. Delphi HP10167 fits the 1986-1988 Ford Bronco II V6 2.9L, and that vehicle takes one hanger.
Does the HP10167 hanger come with a float arm and lock ring?
Yes. Delphi HP10167 comes with the float arm, a seal, a lock ring and an instruction sheet.
How does this Delphi hanger keep the gas gauge reading correct?
This hanger's empty float height and float retention match OE specifications, which is meant to give a correct gas gauge reading.
Can a wrong gas gauge reading mean the fuel pump hanger needs replacing?
A wrong reading can point to the hanger or its float arm if either is the cause. Hard starting is another sign, but other parts can cause it too, so a shop can test it.
Do I need to clean the tank when installing this fuel pump hanger?
Yes. Check and clean the fuel tank before installing, and use the instruction sheet that comes with the hanger for the steps.
