Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7363
$130.99
(You save)
Replace a worn Subaru Forester control arm with the Delphi Suspension Control Arm and Ball Joint Assembly (TC7363), the front right lower unit for the 2009-2013 Subaru Forester, 2011-2014 Subaru Impreza, and 2013-2014 Subaru WRX (see the Buyer's Guide tab for engine-level fitment). This control arm and ball joint assembly locates the wheel and lets it pivot through the suspension's travel, so worn bushings or a failing ball joint — with clunking over bumps, loose steering, or uneven tire wear — can be replaced in one piece.
OE-derived engineering: Delphi applies its OE steering expertise, validating parts from below -40°C to over 120°C and through 720 hours of salt spray, with dimensional and material analysis for OE compatibility.
100% inspection: Every control arm passes crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball stud: Ball studs are machined to micron tolerances for durable, smooth joint operation, and integrated bushings dampen road inputs.
Built to last: Robot welding delivers consistent quality, and anti-corrosion protection is applied to each part for corrosion prevention and appearance.
A quality Delphi control arm for your Subaru Impreza control arm or WRX control arm replacement.
It is the front right (passenger side) lower control arm and ball joint assembly for the listed applications.
Which vehicles does this Delphi control arm fit?
It fits the 2009-2013 Subaru Forester, 2011-2014 Subaru Impreza, and 2013-2014 Subaru WRX. See the Buyer's Guide tab for engine-level fitment.
Does it include the bushings and ball joint?
Yes. This is a complete assembly with the control arm, integrated bushings, and pre-installed ball joint, so you replace the whole unit at once.
What are signs my control arm needs replacing?
Clunking over bumps, loose or wandering steering, and uneven tire wear can indicate worn control arm bushings or a failing ball joint. Diagnose the cause before replacing.
Is the ball stud built for durable operation?
Yes. Delphi machines the ball studs to micron tolerances for smooth joint movement, and every arm passes crack and ultrasonic flaw detection to match OE specifications.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7363
Shopping for a Honda Civic control arm? The Delphi Suspension Control Arm and Ball Joint Assembly (TC1075) is a front right upper unit that installs as a direct-fit replacement on the 1996-2000 Honda...
Keep your front suspension located and tracking properly with the Delphi Suspension Control Arm and Ball Joint Assembly TC1043 — a Honda Accord control arm built with Delphi's OE steering expertise...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Sharpen loose, wandering steering with the Delphi Suspension Control Arm and Ball Joint Assembly TC5364 — a 350Z lower control arm that installs in the front right lower rearward position on the...
Delphi control arm engineering comes to your BMW's rear suspension with the Delphi Suspension Control Arm and Ball Joint Assembly (TC2954). It installs as a direct-fit replacement for the rear left...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
