Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7367
$237.99
(You save)
Tighten up your steering and restore correct wheel geometry with the Delphi control arm and ball joint, MPN TC7367 — a direct-fit replacement for the front right upper position on the 2008-2014 Cadillac CTS. Delphi carries its OE steering engineering into this aftermarket unit, pairing the arm with an integrated ball joint so you renew both wear points in one part.
Tested for OE performance: validated to the extreme — withstands temperatures below -40°C and over 120°C and endures 720 hours of salt spray, with extensive dimensional and material analysis for the best OE-to-aftermarket compatibility.
Quality-checked materials: 100% crack detection and ultrasonic flaw detection confirm the materials match OE specifications.
Precision ball stud: the ball stud is machined to micron tolerances for durability and smooth joint operation.
Built consistent: robot welding delivers consistent quality, and anti-corrosion protection is applied to each part for corrosion prevention and enhanced aesthetics.
This control arm and ball joint assembly locates the wheel while its ball joint lets the steering knuckle pivot as the suspension moves. Clunking or knocking from the suspension, loose or wandering steering, and uneven tire wear are common signs the original arm or ball joint may be worn.
It is a direct-fit replacement for the front right upper control arm and ball joint position on the 2008-2014 Cadillac CTS. See the Buyer's Guide tab to confirm your exact vehicle.
Is this a lower control arm for the Cadillac Cts?
No. The Cadillac Cts lower control arm is a different part — this TC7367 is the front right UPPER control arm with an integrated ball joint.
Does this assembly include the ball joint?
Yes. The ball joint is integrated into the arm, so you replace both wear points in a single unit rather than pressing in a separate joint.
What are signs my Cts control arm needs replacing?
Clunking or knocking from the suspension, loose or wandering steering, and uneven tire wear can indicate the control arm or its ball joint is worn. Diagnose the cause before replacing.
How is this Delphi control arm made?
It uses robot welding for consistent quality, ball studs machined to micron tolerances for smooth operation, and anti-corrosion protection applied to each part.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC7367
Shopping for a Honda Civic control arm? The Delphi Suspension Control Arm and Ball Joint Assembly (TC1075) is a front right upper unit that installs as a direct-fit replacement on the 1996-2000 Honda...
Keep your front suspension located and tracking properly with the Delphi Suspension Control Arm and Ball Joint Assembly TC1043 — a Honda Accord control arm built with Delphi's OE steering expertise...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Sharpen loose, wandering steering with the Delphi Suspension Control Arm and Ball Joint Assembly TC5364 — a 350Z lower control arm that installs in the front right lower rearward position on the...
Delphi control arm engineering comes to your BMW's rear suspension with the Delphi Suspension Control Arm and Ball Joint Assembly (TC2954). It installs as a direct-fit replacement for the rear left...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
