Dorman - OE Solutions Suspension Control Arm and Ball Joint Assembly P/N:522-522
Replace a worn front suspension link in one step with the Dorman control arm with ball joint, part number 522-015. It is a direct replacement for the original assembly in the front left lower position on the 2002-2007 Subaru Impreza. Engine-specific details are in the Buyer's Guide tab.
This Dorman suspension control arm and ball joint assembly arrives with the ball joint and bushings already installed, so there are fewer components to fit during the repair.
As a Dorman lower control arm, it links the steering knuckle to the chassis and lets the wheel travel up and down, while the ball joint acts as the steering pivot. Signs this part may need replacing include clunking over bumps, loose or wandering steering, uneven tire wear, and a torn ball joint boot. This listing covers the front left lower arm. Replacing both sides together is recommended, and a wheel alignment should follow installation.
Interchange: TC9501 · CA12631 · 5CB80284 · RK621892 · GS801142 · CMS801142 · 20202FE150 · 20202FE151 · 20202FE170 · 20202FE171 · 20202FE172 · 20202FE550 · 20202FE551 · 20202FE552
This part cross-references / interchanges with the following part numbers:
Is this the right Subaru Impreza control arm for a 2002-2007 model?
It is listed for the front left lower position on the 2002-2007 Subaru Impreza. The Buyer's Guide tab has the engine and trim details.
What comes pre-installed on this assembly?
The ball joint and bushings come pre-installed, so the arm goes in as one assembly. This helps save time and labor during the repair.
What does a lower control arm do?
It links the wheel's steering knuckle to the vehicle's chassis and lets the wheel move up and down. The ball joint acts as the pivot point for steering.
What are signs the control arm or ball joint may need replacing?
Common signs include clunking over bumps, loose or wandering steering, uneven tire wear, and a torn ball joint boot or worn bushings. Diagnose the cause before replacing parts.
Is a wheel alignment needed after installing it?
A wheel alignment is generally recommended after replacing a control arm. Follow the vehicle service information for the correct fasteners and torque values.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.