Bring the rear-left brake corner back to reliable operation with the Raybestos R-Line Remanufactured Semi-Loaded Disc Brake Caliper and Bracket Assembly (FRC11035). This is a rebuilt OE caliper and bracket unit that clamps the pads against the rotor to slow the wheel. It installs as a direct-fit replacement for the listed applications in the rear-left position: 1999-2002 Chevrolet Silverado 1500, 1999-2002 GMC Sierra 1500, 2000-2001 Chevrolet Tahoe, 2000-2001 GMC Yukon, 2000-2002 Cadillac DeVille, 2003-2005 Chevrolet Astro, and 2003-2005 GMC Safari (All engines).
- Remanufactured OE: castings, guide pins, and brackets are inspected and re-used, then rebuilt with all-new rubber and sealing components.
- New wear parts: seals, boots, bleeder screws, abutment hardware, banjo bolts, and O-rings are replaced with new materials for leak-free operation.
- EPDM70 rubber components for heat resistance, performance, and durability; silicone boots where applicable.
- 100% pressure tested; materials match OE specifications.
Specs: floating caliper type, aluminum casting, 54 mm (2.126 in) piston diameter, and an M10x1 bleeder screw thread. Country of origin: Mexico. If a worn or leaking rear-left caliper is the cause of your braking issue, this assembly replaces it; diagnose the cause before ordering.
Interchange: 18-B4726 · 18B4726 · 99-17305A · 9917305A · 18-P4726 · 18P4726 · 141.66504 · 142.66504 · SC0197 · 10-4374S · 104374S. Manufacturer part number FRC11035.
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What vehicles does this caliper fit?
It is a direct-fit rear-left replacement for the 1999-2002 Silverado 1500 and Sierra 1500, 2000-2001 Tahoe and Yukon, 2000-2002 DeVille, and 2003-2005 Astro and Safari (All engines). See the Buyer's Guide tab.
Which position is this caliper for?
This assembly is cataloged for the rear-left (driver-side rear) position. If you also need the opposite side, order that caliper separately.
Is this a new or remanufactured caliper?
It is a remanufactured OE part. Castings, guide pins, and brackets are inspected and re-used, then rebuilt with all-new seals, boots, bleeder screws, and other rubber components.
Are brake pads included?
This is a semi-loaded caliper and bracket assembly. New seals, boots, bleeder screws, abutment hardware, banjo bolts, and O-rings are included; consult the service information for pads and any additional parts.
What are the caliper's key specs?
It is a floating-type caliper with an aluminum casting, a 54 mm (2.126 in) piston diameter, and an M10x1 bleeder screw thread. It is 100% pressure tested and its materials match OE specifications.
Write a Review