Raybestos Brakes Disc Brake Caliper P/N:FRC11396
Put fresh seals and boots back at the front left wheel with the Raybestos R-Line FRC10674, a remanufactured Ford F-150 brake caliper and bracket assembly built as a direct-fit replacement for the 1997-2001 Ford F-150 and the 2002 Lincoln Blackwood (all engines). This semi-loaded, floating disc brake caliper comes with its mounting bracket, so the caliper and bracket install together.
Specifications: two pistons with a 2.000 in (50.85 mm) piston diameter; cast iron caliper casting (casting number 3727); coated bracket finish; 3/8-24 bleeder screw thread; 14 mm bracket mounting holes with a 2.00 mm thread pitch; dust boots included. Replaces OE part numbers F65Z2B120EA and F75Z2B120BA. Country of origin: Mexico.
The listed applications use one caliper at this position. It is sold individually, and replacing both calipers on the same axle together is recommended for balanced braking. Floating caliper mounting pins use silicone grease. Consult the vehicle service information for the correct fasteners and whether the originals may be reused.
Interchange: 18-B4635 · 99-17868B · 18-B4635S · 18-P4635 · 141.65034 · 142.65034 · 99-17892B · 10-3202S · 14-3202
18B4635 · 9917868B · 18B4635S · 18P4635 · 14165034 · 14265034 · 9917892B · 103202S · 143202 · SC1373
This part cross-references / interchanges with the following part numbers:
Which trucks does the Raybestos FRC10674 fit?
It is a direct-fit front left replacement for the 1997-2001 Ford F-150 and the 2002 Lincoln Blackwood, all engines. Check the "Vehicles it fits" section to confirm your exact application.
What comes with this caliper assembly?
It is a semi-loaded caliper and bracket assembly. The mounting bracket and dust boots are included, and the seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings are replaced with new parts.
What are the key specs of this caliper?
It is a floating caliper with two 2.000 in (50.85 mm) pistons, a cast iron casting, a 3/8-24 bleeder screw thread and 14 mm bracket mounting holes with a 2.00 mm thread pitch.
What brake fluid should I use after installing it?
Use the fluid type recommended by the vehicle manufacturer. It is stamped on the master cylinder reservoir lid. Always use new fluid from a sealed container.
What are signs a brake caliper may need replacing?
Pulling to one side when braking, a dragging brake, fluid leaks at the caliper or uneven pad wear may be signs. Also inspect the slides, the pins and the brake hoses, because they can cause similar symptoms.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.