Keep your front suspension tight and controlled with the Mevotech TTX control arm and ball joint assembly (CTXMS251284). It fits many vehicles, among them the 2014-2026 RAM ProMaster 1500, 2014-2026 RAM ProMaster 2500 and 2014-2026 RAM ProMaster 3500, as a direct-fit replacement for the front left (driver's side) lower position; see the Buyer's Guide tab for the full list. The control arm locates the front wheel and pivots through suspension travel, while the integrated ball joint allows the steering and suspension movement your loaded work van depends on.
Engineered for high-usage commercial vans, fleets and working trucks, this Mevotech TTX lower control arm is built to take a beating:
- Maximum toughness: patented sintered bearings for longer-lasting performance.
- Quick installation: a part-specific slotted castle nut and snap-in cotter pin are provided.
- Superior seal: the Integri-Boot design helps lock out moisture and contaminants.
- Simple to service: an extended 180 SAE grease fitting is included.
- Built tough: cast steel construction made to OE-level tolerances, with a protective surface treatment that resists corrosion.
Clunks over bumps, loose or wandering steering, and uneven tire wear are signs a worn control arm or ball joint may need replacing — diagnose the cause before ordering.
Interchange: 19470673 · 68157803AB
This part cross-references / interchanges with the following part numbers:
19470673, 68157803AB, CTXMS251284
