Hybrid Drive Coolant Temperature Sensor for 1995-2018 Nissan Altima & More - NTK EF0107

NTK EF0107 hybrid drive coolant temperature sensor for the 1995-2018 Nissan Altima and other vehicles sends the ECM an analog signal of the engine coolant temperature. The ECM uses that signal for the air/fuel ratio, cooling fan operation and the temperature gauge.

• Thermal conductive grease inside the brass housing increases sensor response time
• Thermistor placed within the housing for proper output
• Thermal conductive grease gives accurate temperature transfer to the thermistor
• Tested for thermal shock, vibration and OBD verification

Quick facts

• Part: NTK EF0107 hybrid drive coolant temperature sensor
• Also called: engine coolant temperature sensor
• Fits: 1995-2018 Nissan Altima and other vehicles
• Material: Brass housing
• Condition: New

A check engine light, an erratic or dead temperature gauge, or a cooling fan that runs erratically or not at all can mean this sensor is worn, though a wiring connector or the thermostat can be behind the same signs, so find the cause before you replace anything. The sensor may be located on the cylinder head, engine block, thermostat housing or intake manifold.

Fits

The vehicles it fits include the 1995-2018 Nissan Altima, the 2008-2021 Nissan Rogue 4-cylinder 2.5L and the 1995-2022 Nissan Sentra. Wire and probe length match OE. This listing is a single sensor, and the fitment lists one per vehicle.

Specifications

Installation notes

• Thread sealant or o-ring is installed where applicable.
• Mounting clip(s) are included where applicable.