Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5325
$100.99
(You save)
Tighten up sloppy, clunking steering with the Delphi control arm — the Suspension Control Arm and Ball Joint Assembly TC5325, a front left lower unit that serves as a direct-fit replacement for the 2005-2010 Chevrolet Cobalt, 2008-2010 Chevrolet HHR, 2007-2010 Pontiac G5, 2005-2006 Pontiac Pursuit and 2003-2007 Saturn Ion. This control arm and ball joint assembly locates the wheel and pivots the suspension while its integrated ball joint allows steering and travel — if a worn arm or loose joint is the cause of your clunk, wander or uneven tire wear, replacing it addresses that.
OE-matched materials: Delphi control arms undergo 100% crack detection and ultrasonic flaw detection to confirm materials match OE specifications.
Machined ball studs: ball studs are machined to micron tolerances for durable, smooth joint operation.
Robot-welded: robot welding delivers consistent performance and build quality.
Anti-corrosion protection: applied to each part for corrosion prevention and enhanced appearance; tested below -40°C, over 120°C and through 720 hours of salt spray.
Refer to the Buyer's Guide tab to confirm engine-level fitment for your vehicle.
It's a direct-fit replacement for the 2005-2010 Chevrolet Cobalt, 2008-2010 Chevrolet HHR, 2007-2010 Pontiac G5, 2005-2006 Pontiac Pursuit and 2003-2007 Saturn Ion. Check the Buyer's Guide tab to confirm your engine.
Is this a front left lower control arm?
Yes. TC5325 is cataloged as the front left lower position and includes the integrated ball joint.
Does this chevy Cobalt lower control arm come with the ball joint?
Yes. The ball joint is built into the assembly, with its stud machined to micron tolerances for smooth joint operation, so you replace both together in one unit.
What are signs my Chevy HHR control arm may need replacing?
Clunking over the suspension, steering wander, or uneven tire wear can be signs of a worn arm or loose ball joint. Diagnose the cause first, as these symptoms can have other sources.
Will this fit a 2007 chevy Cobalt lower control arm application?
Yes. The 2005-2010 Chevrolet Cobalt is a listed application, so 2007 is covered. Confirm the engine and position in the Buyer's Guide tab.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC5325
Shopping for a Honda Civic control arm? The Delphi Suspension Control Arm and Ball Joint Assembly (TC1075) is a front right upper unit that installs as a direct-fit replacement on the 1996-2000 Honda...
Keep your front suspension located and tracking properly with the Delphi Suspension Control Arm and Ball Joint Assembly TC1043 — a Honda Accord control arm built with Delphi's OE steering expertise...
Steer straight and keep your front suspension tight with the Delphi Suspension Control Arm and Ball Joint Assembly, TC3751 — a direct-fit Honda Civic control arm that drops into the front left lower...
Sharpen loose, wandering steering with the Delphi Suspension Control Arm and Ball Joint Assembly TC5364 — a 350Z lower control arm that installs in the front right lower rearward position on the...
Delphi control arm engineering comes to your BMW's rear suspension with the Delphi Suspension Control Arm and Ball Joint Assembly (TC2954). It installs as a direct-fit replacement for the rear left...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
