Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC1075
Help restore precise wheel location to your luxury Mercedes-Benz with the Delphi control arm and ball joint assembly TC3080, a direct-fit replacement for the front left lower rearward position. It fits many vehicles, among them the 2007-2014 Mercedes-Benz CL600, 2008-2014 Mercedes-Benz CL63 AMG and 2008-2014 Mercedes-Benz CL65 AMG; see the Buyer's Guide tab for the full list. This Delphi control arm combines the arm and an integrated ball joint in one unit, locating the wheel and allowing controlled suspension travel.
Signs this part may need replacing: clunking or knocking from the front suspension, loose or wandering steering, and uneven front tire wear. If a worn control arm or ball joint is the cause, this assembly replaces both in one part; have the cause diagnosed first, since these symptoms can come from other worn components. Sold individually for the front left lower rearward position.
Country of origin: Turkey.
Interchange: 101-7055 · 102-7055 · 102-7623 · 221 330 87 07 · A 221 330 87 07
1017055 · 1027055 · 1027623 · 2213307107 · A2213307107 · 521523 · KSC5463 · KSC5475 · CB28453 · CB28453PR · K620984 · RK620984 · CMS101188 · JTC1358
This part cross-references / interchanges with the following part numbers:
What is the Delphi TC3080 control arm with ball joint?
It's a front left lower rearward suspension control arm with an integrated ball joint. It locates the wheel and allows controlled suspension travel, replacing the arm and joint in one unit.
Which vehicles does the TC3080 fit?
It fits many vehicles, among them the 2007-2014 Mercedes-Benz CL600, 2008-2014 Mercedes-Benz CL63 AMG and 2008-2014 Mercedes-Benz CL65 AMG. See the Buyer's Guide tab for the full list.
What are the signs my control arm may need replacing?
Clunking from the front suspension, loose or wandering steering, and uneven front tire wear. Have the cause diagnosed before replacing, since these symptoms can come from other worn suspension parts too.
How is the Delphi control arm tested?
Delphi validates it below -40°C and above 120°C and through 720 hours of salt spray, with 100% crack and ultrasonic flaw detection and ball studs machined to micron tolerances for smooth operation.
What quality checks does Delphi apply to this control arm?
Delphi applies its OE engineering expertise, robot welding, full crack and ultrasonic inspection, and anti-corrosion protection to each arm for consistent performance and quality.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.