Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXK7424
$134.99
(You save)
Swap out a worn Ram 1500 upper control arm with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly (CTXK7424), a front upper unit engineered for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks. It's a direct-fit replacement for the 2007-2009 Chrysler Aspen, 2004-2009 Dodge Durango and 2002-2005 Dodge Ram 1500 — see the Buyer's Guide tab for engine-level details.
Forged steel construction: upgraded with a structural change and patented sintered bearings for added durability.
Locks out contaminants: a patented sealing ring permanently locks the boot onto the ball joint housing for a superior seal.
High-performance design: rubber bushings with knurling secure the control arm bushing to the sub-frame, plus an application-specific ball stud with a larger sphere.
Repel-TEK surface treatment: helps prevent rust build-up for a longer service life.
Installation is made simpler with the included part-specific slotted castle nut and snap cotter pin, a 180-degree SAE grease fitting for servicing, and pre-applied Nylok thread adhesive to help keep fasteners secure and vibration-resistant.
Frequently Asked Questions
What does this control arm and ball joint assembly do?
It locates the front upper suspension and steering geometry, letting the wheel move through its travel while the integrated ball joint allows steering motion. This CTXK7424 unit replaces a worn factory assembly.
Does the Mevotech TTX CTXK7424 fit my Dodge Ram 1500?
It's a direct-fit replacement for the 2002-2005 Dodge Ram 1500, 2004-2009 Dodge Durango and 2007-2009 Chrysler Aspen. Confirm your exact vehicle in the Buyer's Guide tab.
Is it a front upper control arm?
Yes. This assembly is cataloged as the front upper position for the listed Ram 1500, Durango and Aspen applications.
Does it include installation hardware?
Yes. It comes with a part-specific slotted castle nut and snap cotter pin, plus a 180-degree SAE grease fitting for servicing and pre-applied Nylok thread adhesive on the fasteners.
What are signs this part may need replacing?
Signs may include clunking or looseness in the front end, uneven tire wear, or play in the ball joint. Have the cause diagnosed, since these symptoms can stem from other worn suspension parts too.
Write a Review
MEVOTECH
Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXK7424
Get a strong, easy-installing Mevotech TTX control arm back under your truck or SUV with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly (CTXK80670), a front right upper unit...
Swap out a worn Ram 1500 lower control arm with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly (CTXMS25149), a front left lower unit engineered for high-usage passenger trucks,...
Replace a worn front right lower control arm and ball joint in one bolt-in unit with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly (CTXMS25150), a direct-fit Ram 1500 lower control...
Locate the front wheel and provide its lower pivot with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly CTXK80397, a front right lower unit engineered for high-usage commercial and...
Upgrade your front suspension with the Mevotech TTX control arm and ball joint assembly (MPN CTXMS501240), a heavy-duty replacement for the front right lower position on the 2015-2022 Chevrolet...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
