Delphi FE0512 electric fuel pump for the 1989-1997 Ford Ranger and other vehicles sends fuel from the tank to the engine. This Delphi electric fuel pump sits inside the tank and is sold as a single unit.
- Designed to operate under extreme temperatures with quick engine starts
- Pump design aimed at improved performance and durability
- Designed to bring back fast pressure performance and system integrity with less energy
- Validated and tested pump
- Lower amperage draw puts less load on the vehicle's electrical system
Quick facts
- Part: Delphi FE0512 electric fuel pump
- Fits: 1989-1997 Ford Ranger and other vehicles
- Position: In-tank
- Condition: New
Hard starting, sputtering under load or a whine from the tank can mean the pump is worn. A fuel filter or fuel pressure regulator problem can produce similar symptoms, so find the cause before you replace the pump.
Fits
This pump fits the 1989-1997 Ford Ranger (L4-2.3L or V6-2.9L in 1989, any engine from 1990), the 1994-1997 Mazda B2300 and the 1994-1997 Mazda B4000, and each takes one. If your car is not named here, look up its year and engine under the "Vehicles it fits" section.
Specifications
- Position: in-tank
- Type: electric
- Quantity per vehicle: 1
- Condition: new
In the box
One electric fuel pump, two hose clamps, hose pieces, an insulating sleeve, an isolator, two retaining clips, four seals, a zip tie and an instruction sheet.
Installation notes
- Check and clean the fuel tank before installing the pump.
- Replace the fuel strainer whenever the fuel pump is repaired.
Frequently Asked Questions
Does the Delphi FE0512 fit a 1989 Ford Ranger with the V6-2.9L engine?
Yes. Delphi FE0512 fits the 1989 Ford Ranger with the V6-2.9L or L4-2.3L, and the 1990-1997 Ranger with any engine. Each takes one pump.
Is this fuel pump right for the 1994-1997 Mazda B2300?
Yes. The 1994-1997 Mazda B2300 and the 1994-1997 Mazda B4000 take this pump with any engine, one per vehicle.
Which clamps and seals come with the Delphi FE0512 fuel pump?
Delphi FE0512 comes with two hose clamps, hose pieces, an insulating sleeve, an isolator, two retaining clips, four seals, a zip tie and an instruction sheet.
Is this an in-tank fuel pump?
Yes. This pump mounts in the tank, and its lower amperage draw puts less load on the vehicle's electrical system.
Should the fuel strainer be replaced along with this Delphi pump?
Yes. Put in a new fuel strainer whenever the fuel pump is repaired, and clean the tank before the new pump goes in.
