Raybestos Brakes Disc Brake Caliper P/N:FRC12596
Put new seals, boots and bleeder hardware to work at the front left wheel with the Raybestos R-Line FRC10960, a remanufactured semi-loaded caliper and bracket assembly for the 2000-2005 Ford Excursion, 1999-2004 Ford F-250 Super Duty and 1999-2004 Ford F-350 Super Duty with all engines.
This non-plated disc brake caliper is a remanufactured OE part. Every rubber and sealing component is replaced with new material. The castings, guide pins and brackets are carefully inspected before they are reused, and each caliper is then rigorously tested for reliable braking performance.
Specifications: cast iron caliper casting, 2 in (50.8 mm) caliper piston diameter and an M10x1 bleeder screw thread. Country of origin: Mexico.
This listing is one front left caliper and bracket assembly, and the listed applications use one in this position. Replacing both front calipers together is recommended for even, balanced braking. After installation, bleed the brakes as directed by the vehicle service information.
Interchange: 18-B4689 · 18-B4791 · 99-17729B · 99-17873B · 18-P4689 · 18-P4791 · 141.65040 · 142.65040 · 99-17885B · 99-18044B · 14-3218 · 10-321819
18B4689 · 18B4791 · 9917729B · 9917873B · 18P4689 · 18P4791 · 14165040 · 14265040 · 9917885B · 9918044B · 143218 · 10321819 · SC1327 · SC1383 · BRC292RM
This part cross-references / interchanges with the following part numbers:
Which 2000-2005 Ford Excursion calipers does this replace?
It replaces the front left caliper and bracket assembly on the 2000-2005 Ford Excursion with all engines. Check the Buyer's Guide tab to confirm it fits your vehicle.
Will this 1999-2004 Ford F-250 Super Duty brake caliper also fit the 1999-2004 Ford F-350 Super Duty?
Yes. It is listed for the front left position on the 1999-2004 Ford F-250 Super Duty and the 1999-2004 Ford F-350 Super Duty with all engines.
What is renewed during remanufacturing?
The seals, boots, bleeder screws, abutment hardware, banjo bolts and O-rings are replaced with new materials. The castings, guide pins and brackets are inspected before reuse, and every unit is pressure tested.
What are the caliper's key specs?
It has a cast iron casting, a 2 in (50.8 mm) piston diameter and an M10x1 bleeder screw thread. It comes as a semi-loaded caliper and bracket assembly.
What signs may mean a caliper needs replacing?
Signs include brake fluid leaking at the caliper, pulling to one side, a dragging brake or uneven pad wear. These can have other causes, so diagnose the problem before replacing the caliper.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.