Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXK80670
$188.99
(You save)
Get a strong, easy-installing Mevotech TTX control arm back under your truck or SUV with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly (CTXK80670), a front right upper unit engineered for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks. It drops in as a direct-fit replacement for the listed applications, including the 2007-2016 Chevrolet Tahoe, 2007-2016 Chevrolet Silverado 1500, 2007-2014 Chevrolet Suburban 1500, 2007-2017 Cadillac Escalade, 2007-2016 GMC Sierra 1500 and 2007-2014 GMC Yukon — see the Buyer's Guide tab for the full list.
Stronger build: a forged steel control arm with a reinforced ball joint head and thicker cross section for added durability.
Maximum toughness: patented sintered bearings for longer-lasting performance, plus an application-specific ball stud system with a larger sphere.
Locks out contaminants: a patented sealing ring permanently locks the boot onto the ball joint housing, and Repel-TEK™ surface treatment helps resist rust build-up.
Quick, serviceable install: includes a part-specific slotted castle nut, snap-in cotter pin and a 90-degree SAE grease fitting, with knurled rubber bushings and pre-applied nylok thread adhesive to keep fasteners secure.
Worn control arms or ball joints can show up as clunking over bumps, wandering steering or uneven tire wear; if a failed front right upper arm is the cause, this assembly replaces it.
Frequently Asked Questions
Does this Mevotech TTX control arm fit a Chevy Tahoe?
Yes. CTXK80670 fits the 2007-2016 Chevrolet Tahoe as a front right upper unit, along with the Silverado 1500, Suburban 1500, Cadillac Escalade, GMC Sierra 1500, Yukon and more—see the Buyer's Guide tab.
What position on the vehicle is this assembly?
It is the front right upper control arm and ball joint. Confirm this position matches the part you need for your vehicle before ordering.
Is the ball joint serviceable?
Yes. It includes a 90-degree SAE grease fitting so the ball joint can be greased during service, and a patented sealing ring locks the boot onto the housing to help keep out contaminants.
Does it come with the hardware needed to install it?
It includes a part-specific slotted castle nut and a snap-in cotter pin to secure the ball joint, plus pre-applied nylok thread adhesive on the fasteners.
Should I replace both control arms at the same time?
This listing is for one front right upper assembly. Replacing the matching side at the same time is a common best practice for balanced, even suspension performance.
Write a Review
MEVOTECH
Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXK80670
Anchor the front suspension and locate the wheel with the Mevotech TTX control arm CTXMS401248, a front right lower unit with its ball joint pre-installed. It drops in as a direct-fit replacement for...
Suspension Control Arm and Ball Joint AssemblyMevotech TTX™ parts are engineered with cutting-edge technology to be the strongest, most durable parts on the market. Built for high-usage commercial...
Keep the front suspension tracking true with the Mevotech TTX control arm and ball joint assembly (P/N CTXMS501242), a direct-fit front right upper replacement for the 2015-2022 Chevrolet Colorado...
Keep the front suspension tight and true with the Mevotech TTX front right lower control arm and ball joint assembly (CTXMS401206) — a heavy-duty F-150 control arm engineered for high-usage...
Keep the front suspension located and your steering tracking straight with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly (CTXK8724T), a front right upper F-150 control arm that...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
