Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXMS251285
$200.99
(You save)
Rebuild the front right lower corner of your van's suspension with the Mevotech TTX control arm (CTXMS251285), a front right lower control arm with an integrated ball joint that installs as a direct-fit replacement for the 2014-2026 RAM ProMaster 1500, 2500 and 3500, plus the 2024-2025 RAM ProMaster EV. The control arm locates the wheel while the ball joint allows steering and suspension travel; if the original joint has developed play or its boot has torn, replacing this assembly restores those functions.
Maximum toughness: patented sintered bearings for longer-lasting performance.
Superior seal: Integri-Boot design built into the ball joint helps lock out moisture and contaminants.
Simple to service: extended 180 SAE grease fitting included.
Cast steel construction is built to OE-level tolerances, and a protective surface treatment helps resist rust build-up for added longevity. See the Buyer's Guide tab for engine-level details on your ProMaster.
Interchange: 19470674 · 68157802AB
This part cross-references / interchanges with the following part numbers:
19470674, 68157802AB, CTXMS251285
Frequently Asked Questions
What is the Mevotech TTX suspension control arm and ball joint assembly?
It's the front right lower control arm with an integrated ball joint (MPN CTXMS251285). The arm locates the wheel while the joint allows steering and suspension movement.
Which vehicles does the Mevotech TTX lower control arm fit?
It's a direct-fit replacement for the 2014-2026 RAM ProMaster 1500, 2500 and 3500 and the 2024-2025 RAM ProMaster EV. See the Buyer's Guide tab for engine details.
Is mounting hardware included?
Yes. The assembly comes with a part-specific slotted castle nut, an easy snap cotter pin, and an extended 180 SAE grease fitting for servicing.
What are signs this control arm may need replacing?
Clunking or looseness over the front suspension, uneven tire wear, wandering steering, or a torn ball joint boot are common signs. Diagnose the cause before replacing.
What is the CTXMS251285 built from?
It uses cast steel construction with patented sintered bearings and a corrosion-resistant surface treatment. It is the front right lower unit for the listed applications.
Write a Review
Mevotech TTX
Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXMS251285
Bring back tight, controlled steering on the front-right corner with the Mevotech TTX control arm and ball joint assembly (P/N CTXMS501118). This front right lower unit drops in as a direct-fit...
Give your muscle sedan tight, controlled steering with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly (CTXMS25117) — a Dodge Charger control arm built for the front left upper...
Dial in tight, controlled steering with the Mevotech TTX control arm and ball joint assembly (CTXMS20328), a heavy-duty replacement for the front right (passenger-side) lower position. This complete...
Keep the front suspension tight and true with the Mevotech TTX front right lower control arm and ball joint assembly (CTXMS401206) — a heavy-duty F-150 control arm engineered for high-usage...
Keep the front suspension tracking true with the Mevotech TTX control arm and ball joint assembly (P/N CTXMS501242), a direct-fit front right upper replacement for the 2015-2022 Chevrolet Colorado...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
