Mevotech TTX Suspension Control Arm and Ball Joint Assembly P/N:CTXMS501118
Keep the front end tight and predictable with the Mevotech TTX Suspension Control Arm and Ball Joint Assembly CTXMS861039, a direct-fit Tacoma lower control arm for the 2005-2015 Toyota Tacoma. It installs in the front right lower position, locating the wheel and carrying the integrated ball joint that lets the steering knuckle pivot and travel.
This control arm and ball joint assembly ships ready to install: secure the ball joint to the vehicle with the part-specific slotted castle nut and easy snap cotter pin provided. If a worn control arm bushing or a loose ball joint on your Toyota Tacoma control arm is the cause of front-end clunking, wandering steering, or uneven tire wear, replacing this front right lower assembly addresses it. Sold individually for the front right (passenger-side) position.
Interchange: 102-6429 · 810-84777B · 622.44066 · 623.44066 · 522-720
1026429 · 81084777B · 62244066 · 62344066 · 522720 · 19474606 · TC5788 · CB74064 · CB74064PR · CA14636 · GCA14636 · CK623263 · RK621293 · RK623263 · 5072111 · X50CJ0516 · JTC2522 · 4806804040 · TK621293
This part cross-references / interchanges with the following part numbers:
What vehicles does the CTXMS861039 control arm fit?
It's a direct-fit front right lower control arm and ball joint assembly for the 2005-2015 Toyota Tacoma. See the Buyer's Guide tab to confirm the exact engine and configuration for your truck.
Does this Toyota Tacoma control arm include the ball joint?
Yes. The ball joint is integrated into the assembly, and it ships with the slotted castle nut, cotter pin, and a 180-degree SAE grease fitting for installation and service.
What position does this assembly install in?
The front right (passenger-side) lower control arm position. For balanced handling, inspect the opposite side and replace it if it shows similar wear.
What are signs my Tacoma a arms may need replacing?
Front-end clunking, wandering or loose steering, and uneven tire wear can be signs of a worn control arm bushing or ball joint. Diagnose the cause before replacing.
Is the ball joint greasable?
Yes, it includes a 180-degree SAE grease fitting, and the Integri-Boot design helps keep moisture and contaminants out of the joint.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.