Delphi HP10011 fuel pump and sender assembly for the 1987-1995 Chevrolet G30 and other vehicles holds the pump in the tank and carries the float arm that feeds the gas gauge. This Delphi fuel pump is built to Delphi's OE standards.
- Delphi pump designed to operate under extreme temperatures with quick engine starts
- Metal tubes routed so they never touch the tank, which eliminates noise and vibration during operation
- Empty float height and float retention set for a correct gas gauge reading
- Lower amperage draw puts less load on the electrical system
- Validated and tested before it ships
Quick facts
- Part: Delphi HP10011 fuel pump and sender assembly
- Fits: the 1987-1995 Chevrolet G30 and other vehicles
- Condition: New
A hard start, a stall or a gas gauge that reads wrong can mean this assembly is wearing out. These signs alone do not prove the pump is at fault, since a clogged fuel filter can also cause hard starting and stalling.
Fits
Its fitment includes the 1987-1995 Chevrolet G30, the 1987-1995 GMC G3500 and the 1987-1995 Chevrolet G10, and each takes one.
Specifications
- Quantity per vehicle: 1
- Type: hanger assembly with float arm
- Condition: New
In the box
One fuel pump and sender assembly with float arm, one seal, two O-rings and one instruction sheet.
Installation notes
- Check and clean the fuel tank before installing.
- An instruction sheet comes with the part for the steps.
Interchange: 692-035
25028810 · 25028811 · FLS1016 · 4011080 · 4011221 · 4017230 · E3902 · DHP10011 · 19111397 · E16007 · FG17C · SP17B1H
This part cross-references / interchanges with the following part numbers:
25028810, 25028811, FLS1016, 4011080, 4011221, 4017230, E3902, DHP10011, 692-035, 19111397, E16007, FG17C, SP17B1H
Frequently Asked Questions
Is HP10011 the right Chevrolet G30 fuel pump for a 1987-1995 model?
Yes. Delphi HP10011 fits the 1987-1995 Chevrolet G30, including the 1994-1995 models with V8-5.7L or V6-4.3L. If your vehicle is a different one, look it up in the "Vehicles it fits" section.
What does the Delphi fuel pump assembly HP10011 come with?
Delphi HP10011 comes with the float arm, one seal, two O-rings and an instruction sheet.
Will the float on this fuel pump and sender assembly read the gas gauge correctly?
The empty float height and float retention are set to match OE specifications, which is meant to give a correct gas gauge reading.
Should I clean the tank before fitting this Delphi fuel pump replacement?
Yes. Check and clean the fuel tank before installing, and follow the instruction sheet that comes with Delphi HP10011.
Will this fuel pump and sender assembly make noise against the tank?
It is designed to avoid that. The metal tubes in the hanger are routed so they do not touch the tank at any point, which eliminates noise and vibration during vehicle operation.
