Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3395
$93.99
(You save)
Help keep steering precise and the front suspension quiet with the Delphi control arm and integrated ball joint, MPN TC3395. It installs in the front right lower position as a direct-fit replacement for many vehicles, among them the 2008-2013 Mercedes-Benz C300, 2008-2013 Mercedes-Benz C350 and 2012-2013 Mercedes-Benz E350 — see the Buyer's Guide tab for the full list and engine-level fitment.
OE-validated durability: Delphi applies its OE steering expertise, testing parts below -40°C and above 120°C with 720 hours of salt-spray exposure, plus dimensional and material analysis for OE-matched compatibility.
Inspected to OE specs: every control arm gets 100% crack detection and ultrasonic flaw detection so materials match OE specifications.
Precision ball studs: the ball studs are machined to micron tolerances for durable, smooth joint operation.
Robot-welded and protected: robotic welding delivers consistent quality, and anti-corrosion protection is applied to each part for corrosion prevention and improved appearance.
This control arm and ball joint assembly locates the front wheel and helps control its movement, while the integrated ball joint lets the steering knuckle pivot. Signs this part may need replacing include clunking over bumps, steering wander, or uneven front tire wear. Fit this control arm and pivot assembly to service a worn front right lower corner.
Will this fit as a 2008-2013 Mercedes-Benz C300 control arm?
Yes. It is listed for the 2008-2013 Mercedes-Benz C300, 2008-2013 Mercedes-Benz C350 and 2012-2013 Mercedes-Benz E350. See the Buyer's Guide tab for the full fitment.
Where does this assembly install on the vehicle?
It installs in the front right lower position. Replacing worn suspension in pairs side to side is a good practice for balanced handling, though each side is sold separately.
Does this assembly include the ball joint?
Yes. The ball joint is integrated into this control arm and ball joint assembly, with ball studs machined to micron tolerances for smooth joint operation.
What testing does Delphi perform on this control arm?
Delphi control arms undergo 100% crack detection and ultrasonic flaw detection, and Delphi's testing includes 720 hours of salt-spray exposure.
What are signs this control arm may need replacing?
Signs include clunking over bumps, steering wander, or uneven front tire wear. Have the suspension diagnosed to confirm the control arm or ball joint is the cause before replacing.
Write a Review
Delphi
Delphi Suspension Control Arm and Ball Joint Assembly P/N:TC3395
Help maintain precise wheel location and smooth, controlled steering with the Delphi control arm and ball joint assembly (TC1346), a direct-fit replacement for the rear left upper rearward position...
Help bring back steady steering feel at a worn front corner with the Delphi control arm and ball joint assembly, MPN TC2135. This is a front left upper control arm with the ball joint pre-installed,...
Connect the front suspension to the chassis and give the wheel a proper pivot point with this Delphi control arm with ball joint, part number TC1755, built for the front left upper position. It fits...
Tighten up your BMW's front end with the Delphi control arm and ball joint assembly, MPN TC2329. It installs as a direct-fit replacement in the front right upper position on the 2007-2012 BMW X5 and...
Replace a worn 2008-2012 Nissan Rogue control arm with the Delphi Suspension Control Arm and Ball Joint Assembly TC2467, a front left lower control arm with an integrated ball joint that helps locate...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
